When installing the bathtub faucet, all kinds of impurities in the pipeline should be completely removed, so that the spool damage, blockage, obstruction and leakage can be avoided. At the same time, the exterior should be cleaned so that no residue of building materials will be left. The shower head metal hose should adhere to the natural stretch condition and do not wrap it around the tap when it is not used. When using or not, pay attention to the joint between the hose and the valve body, do not form dead angle, avoid breaking or damaging the hose.

Application method two:

The water nozzle, which is used soon, can sometimes be closed, leakage, loose handle, loosening of the interface and so on. In general, the consumer can handle it by itself. It is unnecessary to use excessive force when switching on any variety of nozzle products. Even the traditional faucets do not require great effort to wring them to death. Especially do not use the handle as a handrail to support or use. After a period of application, the products of the screen fitting screen should be dismantled to remove impurities. Products with hoses should pay attention to making the hoses often adhere to natural conditions and avoid breaking. The seizure in the spiral and stable rubber nozzle is not completely closed. Generally, only the handle (handwheel) should be unloaded when the hard clutter card is howled in the seal. After screwing down the lid and removing impurities from the valve core, it can be restored to normal use.

Application method three:

When the sealing of the ceramic nozzle spool seal is incomplete, it may be that the hard object is scratching the sealing surface or the pre tightening force on the spool can not. If it is the former, it can only be corrected by the after sales service department or the professional repair Department of the nozzle factory. Then one problem is to unload the handle (hand wheel) by the user, and then tighten the spool slightly.

There are usually two reasons for loosening of handle (handwheel): first, when the assembly is neglected, the handle (handwheel) is not properly fastened, but only the screws must be tightened tightly. Two is the handle (handwheel) material selection is poor, the multi attack in the zinc alloy handle (handwheel) and the valve core interface of premature oxidation, corrosion caused by the formation of gap, generally no remedy. Therefore, as far as possible, do not use zinc alloy handle (handwheel) products. If there is leakage at the junction of the nozzle, it is generally necessary to tighten it.

Even a very small object needs to be used and maintained by the application. In order to use the bathtub faucet more comfortably, it is the right way to understand some of the ways.

Article: Kaiping Shuikou Dongfeng Hardware Factory

Http://www.kpdongfeng.com/newsshow.asp? Id=235